UP1/AC 220V 50 Hz Bilge Pump, Rubber Impeller 30 Litres/Minute

£418.26
Excl. Tax: £348.55

Manufacturer: Marco / SKU: 1620011C


Self-priming electric pump for transfer of fresh or salt water with flexible impeller.

 

The UP1 220V pump by Marco features a flexible rubber impeller made of nitrile NBR rubber which allows the problem-free transit of small particles (max Ø5mm).  This pump is a mains voltage product and ideal for larger yachts where 220V is preferred for a bilge pump solution. It is also equally useable in an industrial application where grey water needs to be transferred. This pump can be applied to any application where small particles of dirt or debris may be found in the water.

  • Nickel-plated brass body
  • Shaft in stainless steel
  • Electric motor 0,55 kW
  • Ideal for mains voltage bilge application
  • Ideal for transfer of water with small particles of dirt or debris present

 

Weight 7.840000
Manufacturer Marco
Input Voltage 220Vac
Hose Connection 25mm
Power Consumption 3.3 Amps
EAN Barcode 8022278603174
Liquid Type Fresh + salt water
Flow Rate 30 l/min
Pressure 1 bar
Motor Power 550W
Fuse 4 Amps
Ports (BSP) 1/2"
Partial protection against dust that may harm equipment. Protection against low-pressure jets (6.3 mm) of directed water from any angle (limited ingress permitted with no harmful effects).
Partial protection against dust that may harm equipment. Protection against low-pressure jets (6.3 mm) of directed water from any angle (limited ingress permitted with no harmful effects). IP55

Flexible Impeller

 

The Marco rubber impellerguarantees a high flow rate whilst also allowing the passing of small impurities in waste water. This makes the pumps especially suitable for bilge use on a boat where small debris such as sand and grit may also need to be pumped back overboard. This type of impeller also can handle grey water application.

Available with capacities from 28 litres per minuteup to 45 litres per minute and in versions with an on/off switch or flow reverser switch.

The pumps with flexible rubber impellers are built with a nickel plated brass body and stainless steel shaft, FKM seals and NBR O-rings. They are fitted with a waterproof cable guide and internal brush holder with EMI filter. Pumps comply with ISO 8846 and ISO8849

Product Drawing